![]() When this command is entered, the DSP fax-relay firmware suppresses the V8 call menu (CM) tone, and the fax machines negotiate down to G3 speeds for the fax stream. Allow SG3 fax machines to operate at G3 speeds in fax relay mode. The NSE from the peer gateway can either acknowledge the switch and its readiness to accept packets or indicate that it cannot accept T.38 packets. This timer is configured to tell the terminating gateway how long to wait for an NSE from a peer gateway. The nse-response t38 option sets the timer for awaiting T.38 NSE responses. Define the timeout period for awaiting NSE responses from the dial peer. Define the maximum fax rate for MGCP T.38 sessions. Enter each package you want to add as a separate command. You can also disable support for a package with the no form of this command. Using this command, you can configure additional package capability only for packages that are supported by your call agent. Otherwise, connection requests are refused by the gateway.īy default, certain packages are configured as supported on each platform type. Specify the FXR package for fax transmissions.Įvents specified in the MGCP messages from the call agent must belong to one of the supported packages. Specify the address and protocol of the call agent for MGCP. The UDP port range is from 1025 through 65535. The port option specifies the UDP port for the MGCP gateway. This command also enables control agent redundancy when a backup UCM server is available. This command enables the gateway to communicate with Cisco Unified Communications Manager (UCM) through MGCP. Enable the gateway to communicate with Cisco Unified Communications Manager through the MGCP. The following steps describe how to configure fax pass-through with MGCP gateways. ■ Configure the fax machines to negotiate down to G3 speeds. ■ Adjust the NSE timers for network conditions. ■ Specify the maximum fax rate allowed for MGCP. ■ Specify additional MGCP package capabilities. MGCP Gateway downloads its configuration from CUCM and T1 interface will come up and get registered with CUCM.Ĭisco Collaboration System 10.■ Configure a call agent to work with the gateway.# show mgcp and show mgcp endpint – can be used to verify the MGCP Gateway communication with Communications Manager.Check the Registration status of the MGCP Endpoints and now it has to be registered.Go to CUCM administration page, select Device > Gateway and Click Find to see the list of MGCP gateways.# exit to leave the controller configuration Router(config)# network-clock-participate wic 0 ![]() Router(config)# isdn switch-type primary-ni command Open a telnet session to the router at “Site-1” using putty Configuring MGCP PRI Step13: On Gateway configuration page, configure Step11: Select Digital Access PRI for device protocol Step10: Click the Module icon next to subunit0 filed for port 0/0/1 Sep8: Select VWIC2-2MFT-T1E1- T1 for the subunit 0 Step6: On the Gateway Configuration page, use the following Step5: Choose MGCP from the protocol drop-down menu and click NextĬisco IOS Command “Show diagnostic” will display the voice modules and voice interface cards (VIC) with which the gateway is equipped. Say in this case, Gateway Type: Cisco 2811 Step3: Choose the Appropriate MGCP gateway by gateway or router name Step1: In CUCM 10.x Administration, Choose Device > Gateway. This document explains how to configure the Media Gateway Control Protocol (MGCP) PRI and Gateway integration with the Cisco Unified Communications Manager (CUCM)10.xįollow these steps to add an MGCP gateway to CUCM: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |